Please follow the Wiring diagram correctly when connecting 2 Way switches. It is possible to place a load on each switch. You only need to ensure that if a Load is connected to any one of the terminals on 1 switch the corresponding load on the second switch is kept empty unless both Gangs intend to be used as 1 Way instead of 2 Way.

When the switches are wired correctly the switches should automatically recognise which buttons will be 2 Way. In the even that it does not occur you can simply pair the buttons and also un-pair them if required. The following procedures are as follows:

Pairing 2 buttons:

  1. With the lights off press and hold the light switch on the master button (Master button refers to the button where the load is connected) until you see a flashing blue light and then let go.
  2. Within a 10 second window press the corresponding button on the second switch.

Unpairing buttons:

  1. With the lights off press and hold the light switch on the master button (Slave button refers to the button where no load is connected) until you see a flashing blue light and then let go.
  2. While the blue light is flashing press and hold the button again until the flashing blue light slows down and stops. This will remove the 2 way link.

Please note that when making the switches work 2 way, L1 will work with L1, L2 with L2 and L3 with L3. It is possible to connect a 2 X 2 Gang 2 Way switches and make 2 buttons work as 2 way and remaining buttons work as 1 way each. I LumoS 2 Way Touch Light switches can only work with another 2 Way Touch light switches. They are not compatible with Mechanical Switches

 

2 Way